How to install graphic in the Pit Bikes?

So you have a shiny new graphics kit. Before even thinking out of the envelope need to prepare your dirt bike plastics. If you get this part wrong then you end up with a pretty second rate.

Have a good look at her plastic, if they are pretty scratched and scratched or have some major gouges from a high speed download is worth looking at his replacement. Before applying the kit Motocross Graphics Plastic his dirt bike need to be in reasonable condition.
Replacement aftermarket plastics are pretty affordable these days, OEM (original) plastics can still be expensive, but with companies like Acerbis manufacturing dirt bike plastics for almost any type of bike, wear your bike not have to cost a bomb.
Preparation

First up remove the old stickers, a heat gun or hair dryer helps to soften easy.Then detach him comes the most important of the whole process, the cleaning of plastics. If there is still glue residue on the plastic can be removed with cleaner contact or that I have found that methylated spirits works well.
After removal of the remains of a little hot water and soap and scrub your dirt bike plastics as never before has been erased! They must be perfectly clean. Rinse them off and allow to dry thoroughly.
The implementation of graphics

Now the trick, this will be much easier with two sets of hands to try to get someone to help you. With your heat gun or hair dryer first warm your dirt bike up plastics in particular if it is cold where you're working.

With a large sticker like a radiator shroud, peel a small section of border attack and backrest fold the flat below. You can now paste only the small section of the shroud and put the tag flat against the shroud to make sure everything goes right. Pay attention to the cuts for bolts etc.

If everything seems to be peeling a little more support and continue to work along the way, making sure to squeeze any air bubbles. Apply a little heat as you go, this softens the sticker and makes it easier to stay in the curved sections of its plastics.

Once applied the label of all, squeeze the air bubbles and give a good massage down with a rag while applying a little more heat, this ensures that has stuck well.

If you find anywhere that has an air bubble that you can not squeeze to the edge, just prick with a pin and get rid of the air that way.

I once had some motocross graphics made by a guy whose favorite method of applying stickers was to get a spray bottle filled with soapy water and lightly spray the surface you are using the tag a. Below is peel the backing off the label completely and place the label.

The soapy water is supposed to for you to slide the label into position and then the water below standard and let dry. I have never used this method but if you think you it seems easier, give it a go. GO for more information: www.fiveoracing.com

About the Author:

i AM a big man

Article Source: ArticlesBase.com – How to Install Graphic in the Pit Bikes ?

Mountain biking in the freezing cold – How to stay warm (Rick Rollin’)